Commissioning
6.2 Setting up the operator station
86
Operator’s Manual | 4080T Basic Line | 1000408123 | 05/2019 | [en]
WARNING
Risk of accident from adjusting the seat belt while driving!
Adjusting the seat belt while driving will distract you. This can cause acci-
dents with serious injuries or death.
► Adjust the seat belt before commissioning the vehicle.
► Check by tensile test that the belt buckle is engaged.
Fig.65: Fastening the seat belt
Fastening the seat belt
1. Sit down on the operator seat.
2. Guide the seat belt over the pelvis to the buckle.
ð There must be no twists in the belt.
3. Insert the buckle latch into the belt buckle until it audibly engages.
ð Check correct locking with tension test.
4. Pull the end of the belt to tighten the seat belt.
ð Seat belt is fastened.
Fig.66: Releasing the seat belt
Releasing the seat belt
1. Hold the seat belt.
2. Press the button on the buckle.
ð The latch is released from the buckle.
3. Slowly return the seat belt to the retractor.
6.2.3
Adjusting the steering wheel
WARNING
Danger of accident when adjusting the steering wheel during opera-
tion!
Adjusting the steering wheel during operation may result in an accident,
serious injury or death.
► Adjust the steering wheel before commissioning the vehicle.
► Make sure that the lever for adjusting the steering wheel is engaged.
To Next Page
Loading...
