Commissioning
6.3 Indications in the display
90
Operator’s Manual | 4080T Basic Line | 1000408123 | 05/2019 | [en]
Display for continuous operation of third control cir-
cuit
The symbol indicates that the continuous operation of the
third control circuit is active. Switch off continuous opera-
tion when it is not required.
Differential lock indicator
• No symbol is displayed in the display when the ignition
is switched on.
• When the differential lock push-button is pressed, the
symbol appears on the display.
– When the differential lock push-button is pressed,
the symbol appears on the display.
– When the differential lock push-button is released,
the symbol is no longer displayed.
Display for the engine speed
This readout indicates the current engine speed.
Display for operating hours
The display shows the current operating hours.
Observe inspections after hours of operation.
Display for fuel fill level
Display shows the fuel fill level
Engine temperature display
This indicator shows the engine temperature.
6.3.3
Indication of error messages in the display
Error messages in the form of symbols may appear on the display.
For a detailed description of the error messages: see Malfunctions on
page 225.
Fig.71: Error messages in the dis-
play with symbol
Error messages with symbol
Dirt accumulation on air filter
The symbol appears when the air filter contamination
level is too high.
Clean the air filter and replace it if necessary.
Temperature of coolant too high
The symbol appears if the temperature of the coolant is
too high.
1) Stop the engine.
2) Allow the vehicle to cool down.
3) Clean radiator if necessary.
To Next Page
Loading...
