4.9 Indirect/Read Light Switch
Chapter 4: Removal, Replacement, and Adjustment Procedures
4.9 Indirect/Read Light Switch
Tools required: Phillips head screwdriver Screwdriver
Removal
SHOCK HAZARD:
Locate the involved building circuit breaker panel. Set the involved
circuit breaker to OFF. Lock out and tag out the breaker. Failure to
follow this procedure could result in personal injury or equipment
damage.
1. Set the involved circuit breaker to OFF.
2. Lock out and tag the circuit breaker.
3. Using the phillips head screwdriver, remove the two screws (B) from the
indirect/read light switch faceplate (C) (see figure 4-9 on page 4-20).
Figure 4-9. Indirect/Read Light Switch
m148a019
Page 4 - 20 Integris® 2001 Headwall System Service Manual (man148ra)
To Next Page
Loading...