Need help?Do you have a question about the Wren DRS5004 and is the answer not in the manual?
Steps for connecting CCTV cameras to the DRS unit.
Guide for connecting monitors and audio inputs to the DRS unit.
Instructions for connecting the power cable and power supply.
Explains how to navigate and use the On-Screen Display menu.
Describes the basic setup and connection of the DRS unit.
Details external storage, backup, and network setup.
Procedures for configuring the device's date and time settings.
Confirms and applies the set date and time configurations.
How to configure recording parameters for all channels.
Details on setting recording speed (fps) and quality.
Details on connecting and specifications for sensor inputs.
Steps to configure sensor settings using the OSD menu.
Technical specifications for relay output functionality.
Steps to configure relay output settings using the OSD menu.
How to configure serial ports for Pan/Tilt/Zoom camera control.
Steps to configure COM port settings using the OSD menu.
Connecting ATM/POS/Access Control devices via serial port.
Steps to configure text input settings for external devices.
How to connect and copy images to a USB flash drive.
Details on connecting CCTV cameras and monitors to video ports.
Connecting external storage devices using IEEE1394 ports.
Steps to connect the DRS unit to a network via Ethernet.
Steps to configure IP address, subnet mask, and gateway.
Minimum PC specs and installation guide for DVR Manager.
Using DVR Manager for monitoring live feeds and playback.
General information on monitoring modes and steps.
General| Operating System | Embedded Linux |
|---|---|
| Compression | H.264 |
| Motion Detection | Yes |
| Hard Drive Capacity | Up to 2TB |
| Video Input | 4 channels |
| Video Output | 1 channel |
| Audio Input | 4 channels |
| Audio Output | 1 channel |
| Hard Drive Support | 1 SATA HDD |
| Network Interface | RJ45, 10/100 Mbps |
| USB Interface | 2 x USB 2.0 |
| Remote Viewing | Yes |
To Next Page