Xerox Phaser 6600 - Print Info

Error Troubleshooting
Xerox Internal Use Only Phaser 6600 and WorkCentre 6605
Service Manual
2-33
6. Press the Back button to return to the [Printer Diag] screen.
7. Exit Service Mode. See “How to Exit Service Mode” on page 2-10
Print Info
Printing Printer Configuration Report (Info Page)
You can print the following printer configuration information (A4 size paper is supported) .
•IOT Installed Tray
• IOT ROM Version
• IOT NVM Version
Procedure
1. Enter Service Mode. See “How To Enter Service Mode” on page 2-8.
2. Confirm that the [Printer Diag] is selected, and then press the OK button.
3. Use the [ ] button to select [Print Info], and press the OK button.
4. Press the OK button.
5. Press the OK button to print the printer configuration report. The screen will return to the [Ready]
screen after print.
6. Press the Back button to return to the [Printer Diag] screen.
7. Exit Service Mode. See “How to Exit Service Mode” on page 2-10.
Printer Diag
Engine Diag
Printer Diag
Print Info
Print Info
Info Page
Print Info
Info Page
Info Page
Ready
Info Page
Processing
Info Page
Ready
Printer Diag
Print Info