Xerox Phaser 6600 - System Wiring; Notations Used in the Wiring Diagrams

Wiring
Xerox Internal Use Only Phaser 6600 and WorkCentre 6605
Service Manual
7-21
System Wiring
Notations Used in the Wiring Diagrams
The following table lists the symbols used in the wiring diagrams.
Symbol Description
Denotes a Plug.
Denotes a Jack.
Denotes Pin yy and Jack yy of the connector
Pxx and Jxx.
Denotes a Jumper Point (JPxxx/xxx). Each
end of the Jumper connection has a numeric
designation.
Denotes the parts.
PL X.Y.Z implies the item “Z” of plate (PL)
“X.Y” in Parts List.
Denotes functional parts attached with
functional parts name.
Denotes the control and its outline in the
Board.
Plug
Jack
P/Jxx
YY
Plug and Jack
JPxxx
Jumper
Fuser
PL X.Y.Z
Subassembly 1
Heater
Subassembly 2
Control
Subassembly 3