Error Troubleshooting
Phaser 6600 and WorkCentre 6605 Xerox Internal Use Only
Service Manual
2-54
4. Use the [ ] button to select [Life], and press the OK button.
5. Use the [ ] button to select [Trans Total PV], and press the OK button.
6. Press the OK button to display the value.
Initialize the life counter of Belt Total PV, select [Initializing], and press the OK button.
7. Press the Back button to return to the [Printer Diag] screen.
8. Exit Service Mode. See “How to Exit Service Mode” on page 2-10.
Parameter List Print (Print)
You can print the values of the parameter of the IOT, the error count, and the life count.
CAUTIONS: When you print the parameter list, check that the Tray 1 contains A4 paper (Only A4
paper is supported). If the parameter list is printed on the paper of other than A4, some part of
the image might be lost.
• The printer will display [Processing] and suspend the parameter list from printing, if the
paper size other than A4 is set as the default paper tray setting.
• In this case, switch off the printer once, and on again, specify A4 for the paper tray
setting, enter Service Mode, and then print the list.
Printer Diag
Parameter
Parameter
Regi
Parameter
Life
Life
Fuser PV
Life
Trans Total PV
Trans Total PV
Reading
To Next Page
Loading...
Need help?
General
Weight and Dimensions
