ChipScope Pro Software and Cores User Guide www.xilinx.com 129
UG029 (v14.3) October 16, 2012
ChipScope Pro Analyzer Command Line Options
• Open Cable/Search JTAG Chain: Automatically detects the cable, and queries the
JTAG chain to find its composition
• Turn On/Off Auto Core Status Polling: Green icon means polling is on, red icon
means polling is off. Same as JTAG Chain > Auto Core Status Poll
• Run: Same as Trigger Setup > Run (F5)
• Stop: Same as Trigger Setup > Stop Acquisition (F9)
• Trigger Immediate: Same as Trigger Setup > Trigger Immediate (Ctrl+F5)
• Go To X Marker: Same as Waveform > Go To > Go To X Marker
• Go To O Marker: Same as Waveform > Go To > Go To O Marker
• Go To Previous Trigger: Same as Waveform > Go To > Trigger > Previous
• Go To Ne xt Tr igg er: Same as Waveform > Go To > Trigger > Next
• Zoom In: Same as Waveform > Zoom > Zoom In
• Zoom Out: Same as Waveform > Zoom > Zoom Out
• Fit Window: Same as Waveform > Zoom > Zoom Fit
ChipScope Pro Analyzer Command Line Options
On Windows systems, the ChipScope Pro Analyzer tool can be started either from the
command line or from the Start menu.
• On 32-bit Windows systems, you can invoke the ChipScope Pro Analyzer tool from
the command line by running:
<XILINX_ISE_INSTALL>\bin\nt\analyzer.exe
• On 64-bit Windows systems, you can invoke the ChipScope Pro Analyzer tool from
the command line by running:
<XILINX_ISE_INSTALL>\bin\nt64\analyzer.exe
• On 32-bit Linux systems, you can invoke the ChipScope Pro Analyzer tool from the
command line by running:
<XILINX_ISE_INSTALL>/bin/lin/analyzer
• On 64-bit Linux systems, you can invoke the ChipScope Pro Analyzer tool from the
command line by running:
<XILINX_ISE_INSTALL>/bin/lin64/analyzer
where <XILINX_ISE_INSTALL> represents the location where the Xilinx ISE Design
Suite tools are installed.
Optional Arguments
The following command line options are available, if run from the command line:
-geometry <width>x<height>+<left edge x coord>+<top edge y coord>
Set location, width and height of the ChipScope Pro Analyzer tool program window.
-project <path and filename>
Reads in specified project file at start. Default is not to read a project file at start up.
-init <path and filename>
To Next Page
Loading...
