130 www.xilinx.com ChipScope Pro Software and Cores User Guide
UG029 (v14.3) October 16, 2012
Chapter 4: Using the ChipScope Pro Analyzer
Read specified init file at start up and write to the same file when the ChipScope Pro
Analyzer tool exits. The default is:
%userprofile%\.chipscope\cs_analyzer.ini
-log <path and filename>
-log stdout
Write log messages to the specified file. Specifying stdout writes to standard output.
The default is: $HOME/.chipscope/cs_analyzer.log
Windows Command Line Example
C:\Xilinx\12.3\ISE_DS\ISE\bin\nt\analyzer.exe -log c:\proj\t\t.log -
init C:\proj\t\t.ini -project c:\proj\t\t.cpj -geometry 1000x300+30+600
To Next Page
Loading...
