Xilinx ChipScope Pro User Manual

ChipScope Pro Software and Cores User Guide www.xilinx.com 205
UG029 (v14.3) October 16, 2012
CSE/Tcl Examples
% puts stdout “status = $inputTclArray(status.value)”
% puts stdout “data_bus = $inputTclArray(data_bus)”
2. Get the various activity states of the “status” signal and print them to stdout:
%csevio_read_values $handle $coreRef inputTclArray
% puts stdout “up = $inputTclArray(status.activity_up)”
% puts stdout “dn = $inputTclArray(status.activity_down)”
% puts stdout “sup = $inputTclArray(status.sync_activity_up)”
% puts stdout “sdn = $inputTclArray(status.sync_activity_down)”
Back to list of all CseVIO Tcl Commands
CSE/Tcl Examples
The ChipScope Pro installation includes an example Tcl script that uses the CseJtag Tcl
interface. This example opens a Xilinx Parallel cable or Xilinx Platform USB cable and
scans the JTAG chain and returns information about the devices found in the chain. The
example script is located in the following location:
<XILINX_ISE_INSTALL>\cse\tcl\csejtag_example1.tcl
The script can be run in the Tcl shell (xtclsh) that is included with Xilinx ISE Design Suite or
in the ActiveTcl 8.4 Tcl shell (tclsh) from ActiveState Software Inc. (
[See Reference 24, p.
226]). To run the Tcl example in a command line shell, change to the directory where
csejtag_example1.tcl is located (see above). Next, follow these instructions for the
particular operating system:
• On 32-bit Windows operating systems:
− To use a Xilinx Parallel Cable, type:
<XILINX_ISE_INSTALL>\bin\nt\xtclsh csejtag_example1.tcl -par
− To use a Xilinx Platform Cable USB, type:
<XILINX_ISE_INSTALL>\bin\nt\xtclsh csejtag_example1.tcl -usb
• On 64-bit Windows operating systems:
− To use a Xilinx Parallel Cable, type:
<XILINX_ISE_INSTALL>\bin\nt64\xtclsh csejtag_example1.tcl -par
− To use a Xilinx Platform Cable USB, type:
<XILINX_ISE_INSTALL>\bin\nt64\xtclsh csejtag_example1.tcl -usb
• On 32-bit Linux operating systems:
− To use a Xilinx Parallel Cable, type:
<XILINX_ISE_INSTALL>/bin/lin/xtclsh csejtag_example1.tcl -par
− To use a Xilinx Platform Cable USB, type:
<XILINX_ISE_INSTALL>/bin/lin/xtclsh csejtag_example1.tcl -usb
• On 64-bit Linux operating systems:
− To use a Xilinx Parallel Cable, type:
<XILINX_ISE_INSTALL>/bin/lin64/xtclsh csejtag_example1.tcl -par
− To use a Xilinx Platform Cable USB, type:
<XILINX_ISE_INSTALL>/bin/lin64/xtclsh csejtag_example1.tcl -usb

Xilinx ChipScope Pro Specifications

General

Brand	Xilinx
Model	ChipScope Pro
Category	Computer Hardware
Language	English