Yamaha 55DEHD - Removing the Steering Arm; Checking the Steering Arm; Installing the Steering Arm

BRKT
7-15
6885J11
Bracket unit
Removing the steering arm
1. Fully tilt the swivel bracket up, and then
support it with the tilt stop lever 1.
2. Remove the circlip 2.
3. Remove the steering yoke 3 as shown.
4. Remove the washer, O-ring, bushing,
steering arm, washer, bushing, O-ring,
and bushing.
5
3
4
68870170
2
2
68870160
69D30135
1
Needle bearing attachment 4:
90890-06615
Gear puller 5: 90890-06540
Checking the steering arm
1. Check the steering arm and steering
yoke. Replace the steering arm and
steering yoke if corroded, deformed or
cracked.
Installing the steering arm
1. Install the washer 1, bushing 2, new O-
ring 3 and bushing 4 onto the steering
arm 5.
2. Place the swivel bracket 6 in the upright
position, and then install the steering arm
5 onto the swivel bracket 6.
3. Install the bushing 7, new O-ring 8 and
washer 9 onto the bracket assembly.
4. Fully tilt the swivel bracket up, and then
support it with the tilt stop lever.
4
6
3
2
1
5
68870180
9
8
7
68870190
6885J11_07a 07.10.12 15:16 Page 18