Yamaha 55DEHD - Assembling the Trim Ram; Installing the Tilt Cylinder

BRKT
7-59
6885J11
Bracket unit
Assembling the trim ram
1. Install the new O-ring 1, backup ring 2
onto the trim piston 3.
2. Install the new dust seal 4 and new O-
ring 5 to the trim cylinder end screw 6.
3. Install the trim cylinder end screw 6 onto
the trim ram 7.
1
2
1
2
3
68871160
4
5
6
7
4
5
6
68871170
Installing the tilt cylinder
1. Install the new O-ring 1 to the free pis-
ton 2.
2. Push the free piston 2 into the tilt cylin-
der 3 until it bottoms out.
3. Install the tilt cylinder 3 to the PTT body
4.
4. Install the pipes 5, 6 and 7, onto the
PTT body and then tighten the pipe joints
to the specified torque.
Pipe joints 5:
20 N·m (2.0 kgf·m, 14.8 ft·lb)
Pipe joints 6, 7:
15 N·m (1.5 kgf·m, 11.1 ft·lb)
1
2
3
4
5
6
7
68871180
6885J11_07b_1 07.10.1 9:04 Page 26