Yamaha L2 - Show EEE Capabilities; Show EEE Status

When this command is used to change the settings, link-down temporarily occurs for the corresponding interface.
[Example]
Enable EEE for LAN port #1.
SWR2311P(config)#interface port1.1
SWR2311P(config-if)#eee enable
5.1.7 Show EEE capabilities
[Syntax]
show eee capabilities interface ifname
[Parameter]
ifname : LAN port interface name
Interface to show
[Input mode]
unprivileged EXEC mode, priviledged EXEC mode
[Description]
Shows whether the specified interface supports EEE.
The following items are shown.
Item Description
interface Interface name
EEE(efficient-ethernet) Whether the unit supports EEE
Link Partner Whether the other unit supports EEE
[Note]
If another unit is not connected, the display indicates that EEE is not supported.
[Example]
Show EEE capabilities for LAN port #1.
・If the other unit supports EEE
SWR2311P#show eee capabilities interface port1.1
interface:port1.1
EEE(efficient-ethernet): yes (1000-T, 100-TX)
Link Partner : yes (1000-T, 100-TX)
・If the other unit does not support EEE
SWR2311P#show eee capabilities interface port1.1
interface:port1.1
EEE(efficient-ethernet): yes (1000-T, 100-TX)
Link Partner : not enabled
5.1.8 Show EEE status
[Syntax]
show eee status interface ifname
[Parameter]
ifname : LAN port interface name
Interface to show
[Input mode]
unprivileged EXEC mode, priviledged EXEC mode
[Description]
Shows the EEE status of the specified interface.
The following items are shown.
114 | Command Reference |
Interface control