Yamaha L2 - Set Time of RADIUS Server Usage Prevention; Show Port Authentication Information

[Initial value]
no radius-server key
[Input mode]
global configuration mode
[Description]
Sets the shared password used when communicating with a RADIUS server.
If this command is executed with the "no" syntax, the setting returns to the default.
[Note]
If a server-specific shared password has been set using the radius-server host command, the radius-server host command
settings are used.
[Example]
The shared password used with the RADIUS server is "abcde".
SWR2311P(config)#radius-server key abcde
5.3.22 Set time of RADIUS server usage prevention
[Syntax]
radius-server deadtime time
no radius-server deadtime
[Parameter]
time : <0-1440>
RADIUS server usage prevention time (minutes)
[Initial value]
radius-server deadtime 0
[Input mode]
global configuration mode
[Description]
Sets the time during which the usage of the relevant server is prevented, when a request to the RADIUS server has timed out.
If this command is executed with the "no" syntax, the setting returns to the default.
[Example]
This sets the usage prevention for the RADIUS server to 1 minute.
SWR2311P(config)#radius-server deadtime 1
5.3.23 Show port authentication information
[Syntax]
show auth status [interface ifname]
[Keyword]
interface : Show information for only a specified interface
[Parameter]
ifname : Interface name
Interface to show
[Input mode]
unprivileged EXEC mode, priviledged EXEC mode
[Description]
Shows the setting status for port authentication as well as the current authentication state.
[Example]
Show the port authentication information.
SWR2311P#show auth status
[System information]
144 | Command Reference |
Interface control