Yamaha L2 - Set Poe Power Supply Function (Interface); Set Description of Poe Port

SWR2311P(config)#power-inline enable
Disable the system-wide PoE power supply function.
SWR2311P(config)#power-inline disable
5.6.2 Set PoE power supply function (interface)
[Syntax]
power-inline switch
no power-inline
[Parameter]
switch : PoE power supply function settings for the applicable interface
Setting value Description
enable
Enables the PoE power supply function for the
applicable interface
disable
Disables the PoE power supply function for the
applicable interface
[Initial value]
power-inline enable
[Input mode]
interface mode
[Description]
Set the applicable interface PoE power supply function as enabled or disabled.
If this command is executed with the "no" syntax, the setting returns to the default.
[Note]
This will result in a command execution error on all other ports besides PoE port.
Even if the power supply function is enabled with interface mode, power will not be supplied in the following circumstances.
•
When the system-wide PoE power supply function is disabled
• When the applicable interface mode is in shutdown state
[Example]
Enable the PoE power supply function for port1.1.
SWR2311P(config)#interface port1.1
SWR2311P(config-if)#power-inline enable
Disables the PoE power supply function for port1.1.
SWR2311P(config)#interface port1.1
SWR2311P(config-if)#power-inline disable
5.6.3 Set description of PoE port
[Syntax]
power-inline description line
no power-inline description
[Parameter]
line : Single-byte alphanumeric characters (64 characters or less)
[Initial value]
none
[Input mode]
interface mode
154 | Command Reference |
Interface control