Yamaha L2 - Show HTTP Server Settings; Set Hosts that Can Access the HTTP Server

Listening port number of the secure HTTP server (if omitted: 443)
[Initial value]
http-server secure disable
[Input mode]
global configuration mode
[Description]
Enables the secure HTTP server. You can also specify the listening TCP port number.
If this command is executed with the "no" syntax, the function is disabled.
If the secure HTTP server is enabled, encryption is performed in software, meaning that depending on the amount of traffic, the
CPU usage rate will rise.
To avoid a high usage rate, it is desirable to avoid access by multiple users to an automatically updated web page such as the
dashboard or the LAN map.
[Example]
Start the secure HTTP server with 8080 as the listening port number.
SWR2311P(config)#http-server secure enable 8080
4.15.3 Show HTTP server settings
[Syntax]
show http-server
[Input mode]
priviledged EXEC mode
[Description]
Shows the settings of the HTTP server. The following items are shown.
•
HTTP server function enabled/disabled status
• HTTP server's listening port number
• VLAN interface that is permitted to access the HTTP server
• Filter that controls access to the HTTP server
• Secure HTTP server function enabled/disabled status
• Log-in timeout time
[Example]
Show the settings of the HTTP server.
SWR2311P#show http-server
HTTP :Enable(80)
HTTPS:Disable
Management interface(vlan): 1
Interface(vlan):1
Access:None
Login timeout:30 min 51 sec
4.15.4 Set hosts that can access the HTTP server
[Syntax]
http-server interface interface
no http-server interface interface
[Parameter]
interface : VLAN interface name
[Initial value]
none
[Input mode]
global configuration mode
[Description]
Sets the VLAN interface that allows access to the HTTP server.
Command Reference | Maintenance and operation functions | 71