Yamaha L2 - Set IEEE-802.3 TLV; Set LLDP-MED TLV; Set LLDP Frame Transmission Interval

SWR2311P(config-if)#lldp-agent
SWR2311P(config-lldp)#tlv-select ieee-8021-org-specific
4.19.10 Set IEEE-802.3 TLV
[Syntax]
tlv-select ieee-8023-org-specific
no tlv-select ieee-8023-org-specific
[Initial value]
none
[Input mode]
LLDP agent mode
[Description]
Adds IEEE-802.3 TLVs to transmitted frames.
If this command is executed with the "no" syntax, exclude IEEE-802.3 TLVs from transmitted frames.
This command adds the following TLVs to LLDP frames.
<IEEE-802.3 TLV>
(1) MAC/PHY Configuration/Status : Auto-negotiation support information
(2) Power Via MDI : PoE information (only for models with PoE function)
(3) Maximum Frame Size : Maximum frame size
[Example]
Add IEEE-802.3 TLVs to the LLDP frames that are transmitted on LAN port #1.
SWR2311P(config)#lldp run
SWR2311P(config)#interface port1.1
SWR2311P(config-if)#lldp-agent
SWR2311P(config-lldp)#tlv-select ieee-8023-org-specific
4.19.11 Set LLDP-MED TLV
[Syntax]
tlv-select med
no tlv-select med
[Initial value]
none
[Input mode]
LLDP agent mode
[Description]
If this command is executed with the "no" syntax, exclude LLDP-MED TLVs from transmitted frames.
This command adds the following TLVs to LLDP frames.
<LLDP-MED TLV>
(1) Media Capabilities : Type of LLDP-MED TLV transmitted
(2) Location Identification : Location identification information
(3) Extended Power-via-MDI : Extended PoE information (only for models with PoE function)
[Note]
Location Identification TLV is set to a value of "Location".
[Example]
Add LLDP-MED TLVs to the LLDP frames that are transmitted on LAN port #1.
SWR2311P(config)#lldp run
SWR2311P(config)#interface port1.1
SWR2311P(config-if)#lldp-agent
SWR2311P(config-lldp)#tlv-select med
4.19.12 Set LLDP frame transmission interval
[Syntax]
set timer msg-tx-interval tx_interval
86 | Command Reference |
Maintenance and operation functions