Yamaha L2 - Set Aggregate Policer (Twin Rate)

[Parameter]
CIR : <1 - 102300000>
Traffic rate (kbps)
CBS : <11 - 2097120>
Burst size of conformant token bucket (kbyte)
EBS : <11 - 2097120>
Burst size of excess token bucket (kbyte)
action : Operation for packets categorized by bandwidth class
Setting value Operation
transmit Forward
drop Discard
remark Remarking (CoS/TOS/DSCP)
[Input mode]
aggregate policer mode
[Description]
Specifies a single rate policer as an aggregate policer.
If this is executed with the "no" syntax, metering/policing/remarking processing is deleted.
Metering on the SWR2311P is implemented as a single-rate three-color marker (RFC2697), and the following processing can
be specified for the categorized bandwidth classes.
•
Green : Only forward (cannot be specified)
• Yellow : Choose forward, discard, or remark
• Red : : Choose discard or remark
However, remarking can be specified for either Yellow or Red, not both.
Detailed remarking settings are made using the remark-map command (aggregate policer mode). Regardless of whether action
is set to "remark," remarking is disabled if there are no detailed remarking settings for that bandwidth class. In this case, the
default settings (Yellow: forward, Red: discard) are applied.
[Note]
In order to execute this command, QoS must be enabled.
[Example]
Create an aggregate policer "AGP-01".
• Executing metering by SrTCM with CIR:48kbps, CBS:12kbyte, and EBS:12kbyte
• Yellow: rewrite DSCP value to 10, Red: discard
[Aggregate policer creating]
SWR2311P(config)#aggregate-police AGP-01
SWR2311P(config-agg-policer)#police single-rate 48 12 12 yellow-action remark red-
action drop
SWR2311P(config-agg-policer)#remark-map yellow ip-dscp 10
SWR2311P(config-agg-policer)#exit
9.2.31 Set aggregate policer (twin rate)
[Syntax]
police twin-rate CIR PIR CBS PBS yellow-action action red-action action
no police
[Keyword]
twin-rate : Use twin rate policers
[Parameter]
CIR : <1 - 102300000>
Command Reference | Traffic control | 247