Yamaha L2 - Flow Control; Set Flow Control (IEEE 802.3 X PAUSE Send;Receive) (System); Set Flow Control (IEEE 802.3 X PAUSE Send;Receive) (Interface)

Input value Traffic rate granularity (kbps)
18 - 23476 17.28
23477 - 1000000 261
[Example]
Reduce transmission from queue #0 of LAN port #1 down to CIR:10 Mbps and Bc:64000 byte.
SWR2311P(config)#interface port1.1
SWR2311P(config-if)#traffic-shape queue 0 rate kbps 10000 burst 64
9.3 Flow control
9.3.1 Set flow control (IEEE 802.3x PAUSE send/receive) (system)
[Syntax]
flowcontrol type
no flowcontrol
[Parameter]
type : Flow control operation
Setting value Description
enable Enables flow control
disable Disables flow control
[Initial value]
no flowcontrol
[Input mode]
interface mode
[Description]
Enables flow control for the entire system (IEEE 802.3x PAUSE frames send/receive).
If this is executed with the "no" syntax, flow control is disabled.
[Note]
If the QoS function is enabled, it is not possible to enable flow control for the system.
If flow control is enabled, the tail drop function is automatically disabled.
Flow control for each interface operates only if the flow control settings of the system and of the interface are each enabled.
[Example]
Enable flow control for system.
SWR2311P(config)#flowcontrol enable
9.3.2 Set flow control (IEEE 802.3x PAUSE send/receive) (interface)
[Syntax]
flowcontrol type
no flowcontrol
[Parameter]
type : Flow control operation
Setting value Description
auto Enable flow control auto negotiation
both Enable transmission/reception of Pause frames
disable Disable flow control
258 | Command Reference |
Traffic control