Yamaha L2 - Set MST Instance for Interface; Set Interface Priority for MST Instance

Revision number
[Initial value]
revision 0
[Input mode]
MST mode
[Description]
Sets the revision number of the MST region.
If this command is executed with the "no" syntax, the setting returns to the default.
[Example]
Set the revision number as 2 for the MST region.
SWR2311P(config)#spanning-tree mst configuration
SWR2311P(config-mst)#revision 2
6.3.21 Set MST instance for interface
[Syntax]
spanning-tree instance instance-id
no spanning-tree instance
[Parameter]
instance-id : <1-15>
ID of generated MST interface
[Initial value]
none
[Input mode]
interface mode
[Description]
Sets MST instance for the applicable interface.
If this command is executed with the "no" syntax, the MST instance setting is deleted.
[Note]
This command can be specified only for LAN/SFP port and logical interface.
It is not possible to specify this command for a LAN/SFP port that is associated to a logical interface.
If a LAN/SFP port is associated with a logical interface, the setting of this command for the corresponding LAN/SFP port
returns to the default.
[Example]
Set MST instance #2 for LAN port #1.
SWR2311P(config)#interface port1.1
SWR2311P(config-if)#spanning-tree instance 2
6.3.22 Set interface priority for MST instance
[Syntax]
spanning-tree instance instance-id priority priority
no spanning-tree instance instance-id priority
[Parameter]
instance-id : <1-15>
ID of MST instance specified for the applicable interface
priority : <0-240> (multiple of 16)
Priority value
[Initial value]
spanning-tree instance instance-id priority 128
Command Reference | Layer 2 functions | 183