Yamaha L2 - Set the Device Information Acquisition Time Interval for Downstream of a Wireless AP

• Settings applied
•
Number of terminals connected to the L2MS slave
• Information of terminals connected to the L2MS slave (in the case of a switch)
• MAC address
• Ports connected
• Time at which terminal was discovered
• Information of terminals connected to the L2MS slave (in the case of an AP)
• SSID connected
• Frequency connected
• Time at which terminal was discovered
• If L2MS is operating as slave
• Whether managed by the L2MS master
• MAC address of L2MS master (if managed)
[Note]
Information is not shown if L2MS is not operating.
Specifying "detail" is valid only if L2MS is operating as master.
[Example]
If L2Ms is operating as master, show detailed L2MS information.
SWR2311P>show l2ms detail
Role : Master
[Master]
Number of Terminals : 0
[Slave]
Number of Slaves : 2
[ac44.f230.00a5]
Model name : SWR2311P-10G
Device name : SWR2311P-10G_Z5301050WX
Route : port2.1
LinkUp : 1, 3, 9
Uplink : 1
Downlink : 3
Config : None
Appear time : Tue Mar 13 18:43:18 2018
Number of Terminals : 1
[bcae.c5a4.7fb3]
Port : 9
Appear time : Wed Mar 14 14:01:18 2018
[00a0.deae.b8bf]
Model name : SWR2311P-10G
Device name : SWR2311P-10G_S4L000401
Route : port2.1-3
LinkUp : 1
Uplink : 1
Downlink : None
Config : None
Appear time : Tue Mar 13 18:43:18 2018
Number of Terminals : 0
4.20.11 Set the device information acquisition time interval for downstream of a wireless AP
[Syntax]
wireless-terminal-watch interval time
no wireless-terminal-watch interval
[Parameter]
time : <10-86400>
Acquisition interval (seconds)
[Initial value]
wireless-terminal-watch interval 60
Command Reference | Maintenance and operation functions | 99