Yamaha L2 - Set System Contact; Set System Location

Setting value Description
rmon When RMON event is executed
termmonitor When terminal monitoring is detected
[Initial value]
no snmp-server enable trap
[Input mode]
global configuration mode
[Description]
Specifies the type of trap notification that is sent.
If this command is executed with the "no" syntax, traps are disabled.
[Example]
Enable coldstart trap.
SWR2311P(config)#snmp-server enable trap coldstart
Disable traps.
SWR2311P(config)#no snmp-server enable trap
4.10.3 Set system contact
[Syntax]
snmp-server contact contact
no snmp-server contact
[Parameter]
contact : Name (maximum 255 characters) to register as the system contact
[Initial value]
no snmp-server contact
[Input mode]
global configuration mode
[Description]
Sets the MIB variable sysContact.
sysContact is a variable that is typically used to enter the name of the administrator or contact.
If this command is executed with the "no" syntax, the setting is deleted.
[Example]
Set the system contact to "swr2311padmin@sample.com".
SWR2311P(config)#snmp-server contact swr2311padmin@sample.com
4.10.4 Set system location
[Syntax]
snmp-server location location
no snmp-server location
[Parameter]
location : Name to register as the system location (255 characters or less)
[Initial value]
no snmp-server location
52 | Command Reference |
Maintenance and operation functions