Yamaha L2 - Clear the Authentication State; Setting the Time for Clearing the Authentication State (System); Setting the Time for Clearing the Authentication State (Interface)

5.3.29 Clear the authentication state
[Syntax]
clear auth state [all] [interface ifname]
[Keyword]
all : Clears the authentication state for all supplicants
interface : Clears the authentication state for supplicants connected to specific interfaces
[Parameter]
ifname : Interfacee name
Interface to clear
[Input mode]
priviledged EXEC mode
[Description]
Clears the supplicant authentication state.
[Example]
Clear the authentication state for supplicants connected to LAN port #1.
SWR2311P#clear auth state interface port1.1
5.3.30 Setting the time for clearing the authentication state (system)
[Syntax]
auth clear-state time time
no auth clear-state time
[Parameter]
time : <0-23>
Time at which the authentication state is cleared
[Initial value]
no auth clear-state time
[Input mode]
global configuration mode
[Description]
Sets the time at which the authentication state for the supplicant is cleared for the entire system.
If this command is executed with the "no" syntax, deletes the time setting for clearing the authentication state.
[Note]
If a time has been set to clear the interface authentication state, this will clear the authentication state at the time specified in the
interface.
[Example]
This sets the time at which the authentication state for the supplicant is cleared for the entire system to 12:00.
SWR2311P(config)#auth clear-state time 12
5.3.31 Setting the time for clearing the authentication state (interface)
[Syntax]
auth clear-state time time
no auth clear-state time
[Parameter]
time : <0-23>
Time at which the authentication state is cleared
148 | Command Reference |
Interface control