Yamaha L2 - Show Status of Qos Function Setting; Show Qos Information for LAN;SFP Port

SWR2311P(config-if)#qos trust dscp
Set the trust mode of the LAN/SFP port to the default setting (CoS).
SWR2311P(config-if)#no qos trust
or
SWR2311P(config-if)#qos trust cos
9.2.4 Show status of QoS function setting
[Syntax]
show qos
[Input mode]
unprivileged EXEC mode, priviledged EXEC mode
[Description]
Shows the enabled (Enable) or disabled (Disable) status of the QoS function.
[Example]
Show the status of the system's QoS setting.
SWR2311P#show qos
Enable
9.2.5 Show QoS information for LAN/SFP port
[Syntax]
show qos interface [ifname]
[Parameter]
ifname : Name of the LAN/SFP port. If this is omitted, the command applies to all ports.
Interface to show
[Input mode]
unprivileged EXEC mode, priviledged EXEC mode
[Description]
Shows QoS settings for the specified LAN/SFP port. The following content is shown.
Item Description
Port Trust Mode Trust mode of LAN/SFP port (CoS/DSCP/Port-Priority)
Input Policy-Map Name Name of policy map already applied to the LAN/SFP port
class map information (note 1)
Port Default CoS Priority Default CoS value (note 2)
Port-Priority-Queue Port priority order (note 3)
Egress Traffic Shaping Traffic shaping (individual port)
Egress Traffic Queue Shaping Traffic shaping (individual queue)
Queue Scheduling Egress queue scheduling format and weight
CoS (Queue) CoS - egress queue ID conversion table (note 2)
DSCP (Queue) DSCP - egress queue ID conversion table (note 4)
Special Queue Assignment: Sent From CPU Specify the egress queue of the frames transmitted from the
CPU
Note 1) Not shown if no policy map is applied. For details on class map information, refer to the show class-map command.
Note 2) Shown only for CoS trust mode.
Note 3) Shown only if the trust mode is "port priority."
Note 4) Shown only for DSCP trust mode.
Command Reference | Traffic control | 229