Yamaha L2 - Set DSCP - Egress Queue ID Conversion Tabl; Set Port Priority Order

[Example]
Assign egress queue #4 to CoS value "0".
SWR2311P(config)#qos cos-queue 0 4
Return the egress queue ID of CoS value "0" to the default value.
SWR2311P(config)#no qos cos-queue 0
9.2.8 Set DSCP - egress queue ID conversion tabl
[Syntax]
qos dscp-queue dscp-value queue-id
no qos dscp-queue dscp-value
[Parameter]
dscp-value : <0-63>
DSCP value of the conversion source
queue-id : <0-7>
Egress queue ID corresponding to DSCP value
[Initial value]
See [Note]
[Input mode]
global configuration mode
[Description]
Specifies the values of the DSCP - egress queue ID conversion table that is used to determine the egress queue.
If this is executed with the "no" syntax, the egress queue ID for the specified DSCP value is returned to the default setting.
The DSCP - egress queue ID conversion table is used when the trust mode is set to DSCP.
[Note]
In order to execute this command, QoS must be enabled.
The following table shows the default settings of the DSCP - egress queue ID conversion table.
DSCP value Egress queue
0-7 2
8-15 0
16-23 1
24-31 3
32-39 4
40-47 5
48-55 6
56-63 7
[Example]
Assign egress queue #4 to DSCP value "0."
SWR2311P(config)#qos dscp-queue 0 4
Return the egress queue ID of DSCP value "23" to the default value.
SWR2311P(config)#no qos dscp-queue 23
9.2.9 Set port priority order
[Syntax]
qos port-priority-queue queue-id
no qos port-priority-queue
232 | Command Reference |
Traffic control