Yamaha L2 - Show Egress Queue Usage Ratio

[Note]
In order to execute this command, QoS must be enabled.
[Example]
Show the QoS settings of LAN port #1. (trust mode CoS)
SWR2311P#show qos interface port1.1
Port Trust Mode: CoS
Port Default CoS Priority: 0
Egress Traffic Shaping: Rate 30016 Kbps, Burst 1876 KByte
Queue Scheduling:
Queue0 : Weight 1 ( 5.3%)
Queue1 : Weight 1 ( 5.3%)
Queue2 : Weight 2 (10.5%)
Queue3 : Weight 5 (26.3%)
Queue4 : Weight 5 (26.3%)
Queue5 : Weight 5 (26.3%)
Queue6 : SP
Queue7 : SP
Cos (Queue): 0(2), 1(0), 2(1), 3(3), 4(4), 5(5), 6(6), 7(7)
Special Queue Assignment:
Sent From CPU: Queue7
Show the QoS settings of LAN port #1. (trust mode DSCP)
SWR2311P#show qos interface port1.1
Port Trust Mode: DSCP
Egress Traffic Shaping: Not Configured
Queue Scheduling:
Queue0 : SP
Queue1 : SP
Queue2 : SP
Queue3 : SP
Queue4 : SP
Queue5 : SP
Queue6 : SP
Queue7 : SP
DSCP (Queue): 0(2), 1(2), 2(2), 3(2), 4(2), 5(2), 6(2), 7(2)
8(0), 9(0), 10(0), 11(0), 12(0), 13(0), 14(0), 15(0)
16(1), 17(1), 18(1), 19(1), 20(1), 21(1), 22(1), 23(1)
24(3), 25(3), 26(3), 27(3), 28(3), 29(3), 30(3), 31(3)
32(4), 33(4), 34(4), 35(4), 36(4), 37(4), 38(4), 39(4)
40(5), 41(5), 42(5), 43(5), 44(5), 45(5), 46(5), 47(5)
48(6), 49(6), 50(6), 51(6), 52(6), 53(6), 54(6), 55(6)
56(7), 57(7), 58(7), 59(7), 60(7), 61(7), 62(7), 63(7)
Special Queue Assignment:
Sent From CPU: Queue7
9.2.6 Show egress queue usage ratio
[Syntax]
show qos queue-counters [ifname]
[Parameter]
ifname : Name of the LAN/SFP port. If this is omitted, the command applies to all ports.
Interface to show
[Input mode]
unprivileged EXEC mode, priviledged EXEC mode
230 | Command Reference |
Traffic control