Yamaha L2 - Page 190

• Setting of the loop detection function (loop-detect) for LAN/SFP port. If the loop detection function is operating, (*) is
added
•
Status of the Port Blocking setting (port-blocking)
• Loop detection status (status)
[Example]
Show the loop detection status.
SWR2311P>show loop-detect
loop-detect: Enable
port loop-detect port-blocking status
-------------------------------------------------------
port1.1 enable(*) enable Detected
port1.2 enable(*) enable Blocking
port1.3 enable(*) enable Normal
port1.4 enable(*) enable Normal
port1.5 enable(*) disable Normal
port1.6 enable(*) enable Normal
port1.7 enable(*) enable Shutdown
port1.8 disable enable ------
port1.9 enable enable Normal
: : : :
-------------------------------------------------------
(*): Indicates that the feature is enabled.
190 | Command Reference |
Layer 2 functions