WIRE ROUTING DIAGRAM
7-13
1
2
3
4
5
6
7
8
9
10
SPECIFICATIONS
1. Spark plug cap 4. Charging coil lead
2. Oil level switch lead 5. Solenoid (equipped models)
3. Clamp
A. The spark plug cap should face the direction indicated in the illustration.
B. Pass the lead under the throttle stop screw. (When shipment from the factory)
C. Route the lead as shown.
D. Fold the clamp as shown.
E. Pass the lead through the hole in the crankcase.
F. Screw in the high tension cord until it touches the spark plug cap.
To Next Page
Loading...
