Yamaha MX360 - Page 52

ENGINE INSPECTION
3-2
1
2
3
4
5
6
7
8
9
10
ENGINE
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
Testing steps (below the minimum specification):
a. Squirt a few drops of oil into the cylinder.
b. Measure the compression again.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
Testing step (above the maximum specification):
a. Check the cylinder head, valve surfaces, and piston
crown for carbon deposits.
Carbon deposits  Eliminate
.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
5.
Install:
• Spark plug
• Spark plug cap
Reading Diagnosis
Higher than
without oil
• Worn cylinder, piston, and piston ring(s)
Same as
without oil
• Defective piston, piston ring(s), valve(s), and
cylind
er head gasket
• Improper valve timing and valve clearance
Spark plug:
20 N·m (2.0 kgf·m, 15 lb·ft)
T
R
.
.