7-19
1
2
3
4
5
6
7
8
9
10
SPECIFICATIONS
WIRE ROUTING DIAGRAM
1. Hose clamp 7. Fuel filter
2. Low-pressure fuel pump 8. Plastic locking tie
3. Fuel delivery hose 9. Lead 1
4. Fuel injector pipe 1 10.Purge hose 1
5. Fuel hose 11.Pulsar hose
6. High-pressure fuel pump
A. • Install the air filter case cover as shown in the illustration.
• The locking claw should be fixed securely to the groove of the case.
B. Insert the hose until it reaches the end as shown in the illustration.
C. Install white painted portion in the direction shown in the illustration.
D. Install the plastic locking tie at the position shown in the illustration.
E. Fuel delivery hose installation details
F. Install with the yellow painted portion on top.
G. The position of the binding area of the plastic locking tie should be on the engine side.
H. Keep the length shown in the illustration to 0–2.0 mm (0–0.08 in) and cut off the end of the plastic lock-
ing tie.
I. Pulsar hose installation details
J. Install the yellow painted portion in the direction shown in the illustration.
To Next Page
Loading...
