7-23
1
2
3
4
5
6
7
8
9
10
SPECIFICATIONS
WIRE ROUTING DIAGRAM
1. Air filter cover 1 4. Joint 2
2. Air filter case stay 5. Air filter case
3. Breather hose
A. Install the air filter case stay into the groove in the air filter case.
B. Install the screw in the direction shown in the illustration.
C. Insert the protector side of the purge hose 1 all the way into the pipe of the throttle body.
D. 19–21 mm (0.75–0.83 in)
E. Install the white painted portion in the direction shown in the illustration.
F. Insert the breather hose all the way into the pipe of the joint 1.
G. Insert the joint 2 until it contacts the projection on the joint 1.
H. 2.0–4.0 mm (0.08–0.16 in)
I. Insert the air filter cover 1 until it contacts the air filter case.
J. Installation angle of joint 2 15.75 (reference value)
K. Install the joint 2 in the direction shown in the illustration.
L. Insert from 22 mm (0.87 in) until contact is made as shown in the illustration.
M. The air filter case and joint 2 should not be bent or detached due to unreasonable installation.
N. Install the air filter case in the direction shown in the illustration.
O. 5–7 mm (0.20–0.28 in)
To Next Page
Loading...
