10 Error
FS100 10.1 Error Message
10-1
10 Error
10.1 Error Message
Error warns the operator not to advance to the next operation caused by a
wrong operation or the access method when using the programming
pendant or an external equipment (computer, PLC, etc.).
When an error occurs, confirm the content of the error then release the
error.
To release the error, perform either of the following operations:
• Press [CANCEL] on programming pendant.
• Input alarm/error reset signal (system input).
When two or more errors occur, appears in the message display area.
Activate the message display area and press [SELECT] to view the list of
current errors.
An error is different from an alarm because it does not stop
the robot even if it occurred while the robot was operated
(during playback).
To Next Page
Loading...
