YASKAWA FS100 - 8.3.2.3 Modifying the Output Status

8 System Diagnosis
FS100 8.3 Input/Output Status
8-4
8.3.2.3 Modifying the Output Status
The status of universal output signal can be changed by the operation
below.
1. Select the desired output signal number.
– Select the status of
the desired output signal, “” or “” in the
UNIVERSAL OUTPUT window.
2. Press INTER LOCK key + [SELECT].
– The status is changed. (: ON status, : OFF status)
NOTE
The status of universal output signal can be changed only
when the mode is set to the teach mode.
INTER
LOCK