YASKAWA FS100 Service Manual

10 Error
FS100 10.1 Error Message
10-15
10.1.6 Maintenance Mode
Error No. Data Error Message Contents
8010 - Too many axes
8011 - Choose the input of overrun
8020 - Too many I/O points
8030 - Too many boards (DEVICENET)
8033 - Too many boards
8034 - Too many channels
8035 - Invalid configuration
8040 - Memory error (ControlNet output
condition)
8041 - Memory error (UNIWIRE
CONNECT DAT
8042 - Memory error(IP Network
Configuration data)
8050 - Robot model is not registered
8051 - Select model
8060 - Cannot get UNIWIRE
connection data
8070 - DHCP is already set to use for
another item
8071 - DNS is already set to use for
another item
8072 - DHCP is not set to use
8073 - DNS is not set to use
8074 - Device Information not found
8075 - Unable to accept same type of
boards simultaneously
8076 - Ethernet is being used by other
function.
8080 - Non support function
8205 - ENABLE Unit over
8206 - FLASH access error
8210 - IO module configuration is not
modified
8211 - OPTION, BOARD or MODULE
SETUP is not completed.
8212 - Cannot change setting (Function
conflict
8213 - Check EXTERNAL IO setup

YASKAWA FS100 Specifications

General

Brand	YASKAWA
Model	FS100
Category	Controller
Language	English