YASKAWA SGDA series - Resetting Servo Alarms

4.1Basic Operations
169
4.1.2 Resetting Servo Alarms
Servo alarms can be reset using the Digital Operator. (Servo alarms can also be reset by the
1CN-18, ALMRST
input signal. Refer to 3.7.1 for details.)
Type: JUSP-OP02A-1
Press
Type: JUSP-OP03A
simultaneously
.
Alarm Reset
Press
Alarm Reset
NOTE After an alarm occurs, remove the cause of the alarm before resetting it. Refer to Section
6.2 Troubleshooting to determine and remedy the cause of an alarm.
4