Yealink T29G

Configuring Advanced Features
353
Parameters
Permitted Values
Default
Description:
Configures the label to be displayed on the LCD screen when receiving the RTP
multicast.
Example:
multicast.listen_address.1.label = Paging1
Web User Interface:
Directory->Multicast IP->Label(Multicast Listening)
Phone User Interface:
None
multicast.receive_priority.enable
0 or 1
1
Description:
Enables or disables the IP phone to handle the incoming multicast paging calls
when there is an active multicast paging call on the IP phone.
0-Disabled
1-Enabled
If it is set to 1 (Enabled), the IP phone will answer the incoming multicast paging call
with a higher priority and ignore that with a lower priority.
Web User Interface:
Directory->Multicast IP->Paging Priority Active
Phone User Interface:
None
multicast.receive_priority.priority
Integer from 0 to 10
10
Description:
Configures the priority of multicast paging calls.
1 is the highest priority, 10 is the lowest priority.
If it is set to 0, all incoming multicast paging calls will be automatically ignored.
Web User Interface:
Directory->Multicast IP->Paging Barge
Phone User Interface:
None
To configure a listening multicast address via web user interface:
1. Click on Directory->Multicast IP.