Yealink T29G

Administrator’s Guide for SIP-T2_Series_T4_Series IP Phones
412
Navigate to:
http://<phoneIPAddress>/servle
t?p=network-adv&q=load
Phone User Interface
Configure CDP feature.
Details of Configuration Parameters:
Parameters
Permitted Values
Default
network.cdp.enable
0 or 1
0
Description:
Enables or disables CDP feature on the IP phone.
0-Disabled
1-Enabled
Note: If it is set to 1, the IP phone will attempt to determine its VLAN ID through CDP.
If you change this parameter, the IP phone will reboot to make the change take
effect.
Web User Interface:
Network->Advanced->CDP->Active
Phone User Interface:
Menu->Settings->Advanced Settings (default password: admin)
->Network->CDP->CDP Status
network.cdp.packet_interval
Integer from 1 to 3600
60
Description:
Configures the interval (in seconds) for the IP phone to send the CDP request.
Note: If you change this parameter, the IP phone will reboot to make the change
take effect. It works only if the parameter “network.cdp.enable” is set to 1
(Enabled).
Web User Interface:
Network->Advanced->CDP->Packet Interval (1~3600s)
Phone User Interface:
Menu->Settings->Advanced Settings (default password: admin)
->Network->CDP->CDP Interval
To configure CDP via web user interface:
1. Click on Network->Advanced.
2. In the CDP block, select the desired value from the pull-down list of Active.