YOKOGAWA CA150 User Manual

8-6
IM CA150E
CD Normal SettingSets the source value during calibration
× ○*Command = CD<Delimiter> → Answer = CD <Delimiter>
During generation in calibration mode, sets the current output source
values as the calibration values for the selected function, range, and
scale (+FS/0).
CL Normal SettingSets and queries the calibration item
× ○*Command = CLm<Delimiter> → Answer = CLm <Delimiter>
Command = CL?<Delimiter>
→ Return = CLm <Delimiter>
Parameter m=3: (Calibration) Source/4: (Calibration) Measure
CMF Normal SettingSets and queries the calibration measurement function
× ○* Command = CMFm<Delimiter> → Answer = CMFm <Delimiter>
Command = CMF?<Delimiter>
→ Return = CMFm <Delimiter>
Parameter
m=0: DCV/1: DCA/2: Ω
default Value of m=0 (DCV)
CP Normal SettingSets the calibration point
× ○*Command = CPm<Delimiter> → Answer = CPm <Delimiter>
Parameter
m=0: + FS Calibration/1: + Zero Calibration/2: -FS Calibration
CS Normal SettingSets the measurement value during calibration
× ○*Command = CS<Delimiter> → Answer = CS <Delimiter>
During measurement in calibration mode, sets the current input
measurement values as the calibration values for the selected function,
range, and scale (+FS/0/-FS ).
CSF Normal SettingSets and queries the calibration source function
× ○*Command = CSFm<Delimiter> → Answer = CSFm <Delimiter>
Command = CSF?<Delimiter>
→ Return = CSFm <Delimiter>
Parameter m=0: DCV/1: DCA/2: Ω
default Value of m=0 (DCV)
CW Normal SettingWrites the calibration data
× ○ *Command = CW<Delimiter> →
Answer = CW, OK<Delimiter> (Normal End)
Writes to EEPROM after calibrating each function and range.
If the power is turned off without executing this command, the values that
were calibrated just before are discarded.
*: Can only be used in calibration mode of setting mode.
8.3 Detailed Description of Commands

YOKOGAWA CA150 Specifications

General

Brand	YOKOGAWA
Model	CA150
Category	Test Equipment
Language	English