33
Introduction
Control Panel Display
8/23/12 P1051584-002
Set Applicator Error Signal When Print Engine Pauses
When this option is enabled and the print engine is paused, the
print engine sets the applicator error state.
See Error on Pause on page 80 for more information.
Set the Ribbon Low Mode
The Ribbon Low feature determines if the print engine will
generate a warning when the amount of ribbon left on the roll gets
low.
See Ribbon Low Mode on page 81 for more information.
Set the Ribbon Low Output
When the Ribbon Low feature is enabled, this parameter
determines if the output signal on Pin 9 is HIGH or LOW.
See Ribbon Low Output on page 81 for more information.
Set the Reprint Mode
When reprint mode is enabled, you can reprint the last label printed
either by issuing certain commands or by pressing the LEFT
ARROW on the control panel.
See Reprint Mode on page 81 for more information.
To Next Page
Loading...