Printer Configuration and Adjustment
Changing Printer Settings
78
P1051584-002 8/23/12
Maximum
Label Length
Set the maximum label length to a value that is at least 1.0 in. (25.4 mm) greater than the
actual label length plus the interlabel gap. If you set the value to one that is smaller than the
label length, the print engine assumes that continuous media is loaded, and the print engine
cannot calibrate.
For example, if the label length is 6.0 inches (152 mm) including the interlabel gap, set the
parameter for at least 7.0
inches (178 mm).
Accepted values:
0 to the maximum label length supported by the printer
Related ZPL command(s): ^ML
SGD command used:
none
Control panel menu item:
MAXIMUM LENGTH on page 23
Printer web page:
View and Modify Printer Settings > Media Setup >
Maximum
Length
Table 5 • Print Settings (Continued)
2
1
Label length (including interlabel gap)
2
Interlabel gap
3
Set the maximum label length to approximately
this value
1
3
To Next Page
Loading...
Need help?
General
Weight and Dimensions
