Zte ZXR10 ZSR V2 - Page 79

Chapter6OSPFv3Conguration
StepCommandFunction
1ZXR10(config-ospfv3-process-id)#interface
<interface-name>[area<area-id>][instance<0~255>]
Addsaninterfaceto
OSPFv3.
ZXR10(config-ospfv3-process-id-if-interface-
name)#hello-interval<interval>
Speciestheintervalof
sendingHellopacketsonan
interfaceinseconds,range:
1to65535.
Thedefaultvaluefor
point-to-pointand
broadcastinterfacesis
10seconds.
Thedefaultvaluefor
non-broadcastand
point-to-multipoint
interfacesis30seconds.
ZXR10(config-ospfv3-process-id-if-interface-
name)#retransmit-interval<interval>
Speciesthetimeinterval
(inseconds)atwhichan
interfaceretransmitsanLSA,
range:1to65535,default:5.
ZXR10(config-ospfv3-process-id-if-interface-
name)#transmit-delay<interval>
Speciesthedelay(in
seconds)afterwhichan
interfacetransmitsalink
stateupdatepacket,range:
1to65535,default:1.
ZXR10(config-ospfv3-process-id-if-interface-
name)#dead-interval<interval>
Speciestheagingtime(in
seconds)ofneighborsonan
interface,range:1to65535.
Thedefaultvaluefor
point-to-pointand
broadcastinterfacesis
40seconds.
Thedefaultvaluefor
non-broadcastand
point-to-multipoint
interfacesis120seconds.
ZXR10(config-ospfv3-process-id-if-interface-
name)#cost<cost-value>
Setstheinterfacecostvalue
(inseconds),range:1to
65535.
ZXR10(config-ospfv3-process-id-if-interface-
name)#priority<value>
Setstheinterfacepriority(in
seconds),range:0to255,
default:1.
2
6-9
SJ-20140504150128-018|2014-05-10(R1.0)ZTEProprietaryandCondential