Chapter 25 IPSec VPN
ZyWALL USG 100/200 Series User’s Guide
511
Router identity consists of ID type and content. The ID type can be domain name,
IP address, or e-mail address, and the content is a (properly-formatted) domain
name, IP address, or e-mail address. The content is only used for identification.
Any domain name or e-mail address that you enter does not have to actually
exist. Similarly, any domain name or IP address that you enter does not have to
correspond to the ZyWALL’s or remote IPSec router’s properties.
The ZyWALL and the remote IPSec router have their own identities, so both of
them must store two sets of information, one for themselves and one for the other
router. Local ID type and content refers to the ID type and content that applies to
the router itself, and peer ID type and content refers to the ID type and content
that applies to the other router.
Note: The ZyWALL’s local and peer ID type and content must match the remote
IPSec router’s peer and local ID type and content, respectively.
For example, in Table 135 on page 511, the ZyWALL and the remote IPSec router
authenticate each other successfully. In contrast, in Table 136 on page 511, the
ZyWALL and the remote IPSec router cannot authenticate each other and,
therefore, cannot establish an IKE SA.
It is also possible to configure the ZyWALL to ignore the identity of the remote
IPSec router. In this case, you usually set the peer ID type to Any. This is less
secure, so you should only use this if your ZyWALL provides another way to check
the identity of the remote IPSec router (for example, extended authentication) or
if you are troubleshooting a VPN tunnel.
Additional Topics for IKE SA
This section provides more information about IKE SA.
Table 135 VPN Example: Matching ID Type and Content
ZYWALL REMOTE IPSEC ROUTER
Local ID type: E-mail Local ID type: IP
Local ID content: tom@yourcompany.com Local ID content: 1.1.1.2
Peer ID type: IP Peer ID type: E-mail
Peer ID content: 1.1.1.2 Peer ID content: tom@yourcompany.com
Table 136 VPN Example: Mismatching ID Type and Content
ZYWALL REMOTE IPSEC ROUTER
Local ID type: E-mail Local ID type: IP
Local ID content: tom@yourcompany.com Local ID content: 1.1.1.2
Peer ID type: IP Peer ID type: E-mail
Peer ID content: 1.1.1.20 Peer ID content: tom@yourcompany.com
To Next Page
Loading...
