Chapter 51 Log and Report
ZyWALL USG 100/200 Series User’s Guide
896
Remote Server
1~4
For each remote server, use the Selection drop-down list to change the
log settings for all of the log categories.
disable all logs (red X) - do not send the remote server logs for any log
category.
enable normal logs (green check mark) - send the remote server log
messages and alerts for all log categories.
enable normal logs and debug logs (yellow check mark) - send the
remote server log messages, alerts, and debugging information for all
log categories.
# This field is a sequential value, and it is not associated with a specific
entry.
Log Category This field displays each category of messages. It is the same value used
in the Display and Category fields in the View Log tab. The Default
category includes debugging messages generated by open source
software.
System log Select which events you want to log by Log Category. There are three
choices:
disable all logs (red X) - do not log any information from this category
enable normal logs (green check mark) - create log messages and
alerts from this category
enable normal logs and debug logs (yellow check mark) - create log
messages, alerts, and debugging information from this category; the
ZyWALL does not e-mail debugging information, however, even if this
setting is selected.
E-mail Server
1 E-mail
Select whether each category of events should be included in the log
messages when it is e-mailed (green check mark) and/or in alerts (red
exclamation point) for the e-mail settings specified in E-Mail Server 1.
The ZyWALL does not e-mail debugging information, even if it is
recorded in the System log.
E-mail Server
2 E-mail
Select whether each category of events should be included in log
messages when it is e-mailed (green check mark) and/or in alerts (red
exclamation point) for the e-mail settings specified in E-Mail Server 2.
The ZyWALL does not e-mail debugging information, even if it is
recorded in the System log.
Remote Server
1~4
For each remote server, select what information you want to log from
each Log Category (except All Logs; see below). Choices are:
disable all logs (red X) - do not log any information from this category
enable normal logs (green check mark) - log regular information and
alerts from this category
enable normal logs and debug logs (yellow check mark) - log regular
information, alerts, and debugging information from this category
OK Click this to save your changes and return to the previous screen.
Cancel Click this to return to the previous screen without saving your changes.
Table 260 Configuration > Log & Report > Log Setting > Active Log Summary
LABEL DESCRIPTION
To Next Page
Loading...
