Chapter 9 VDSL Setup
VES1724-56 User’s Guide
103
9.2 VDSL Line Setup
Click VDSL Setup > VDSL Line Setup to display the screen as shown next. Use this screen to
select the primary VDSL template, secondary VDSL template, and alarm template for each
subscriber port.
Configure VDSL templates in VDSL Setup > VDSL Profile (see Section 9.3 on page 104).
Configure VDSL alarm templates in VDSL Setup > VDSL Alarm Profile (see Section 9.4 on page
121).
Figure 53 VDSL Line Setup
The following table describes the labels in this screen.
Table 32 VDSL Line Setup
LABEL DESCRIPTION
Port This is the port number of a subscriber port.
Primary Template Select a VDSL template for a port. The template is used when the line is first
initiated.
Fallback Template Select a VDSL template for a port. This template is used when the line failed
to be initialized using the primary template. See Primary and Fallback VDSL
Templates Example on page 102.
Alarm Template Select a VDSL alarm template for a port. The Switch sends an SNMP trap
(alarm) when a parameter value is over one of the pre-defined thresholds on
the line.
Apply Click this to save the settings to the Switch.
Cancel Click Cancel to clear the selected checkboxes in the Delete column.
To Next Page
Loading...
