ZyXEL Communications VES1724-56 - PPPoE IA Global Configuration

Chapter 32 PPPoE IA
VES1724-56 User’s Guide
291
The following table describes the labels in this screen.
32.4 PPPoE IA Global Configuration
Click Advanced Application > PPPoE IA Configuration in the navigation panel, and then click
the Global link to display the screen as shown. Use this screen to configure the global PPPoE IA
settings the Switch applies to all PPPoE clients.
You can additionally configure whether to add/replace PPPoE IA option 82 tags on a per-port basis
in the Basic Setting > Port Setup screen (see Section 8.9 on page 82).
Figure 179 Advanced Application > PPPoE IA Configuration > Global
Table 134 Advanced Application > PPPoE IA Configuration > Port Tel
LABEL DESCRIPTION
Port This field shows the number of a DSL port and the VDSL port bonding group ID if the port
has joined one.
Telephone
number
Enter a string or digits to represent the port’s telephone number. Spaces are not allowed.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.