ZyXEL Communications VES1724-56 - Per Queue Ratelimit Profile

Chapter 8 Basic Setting
VES1724-56 User’s Guide
85
The following table describes the labels in this screen.
8.10.1 Per Queue Ratelimit Profile
You can also use per queue rate limit profiles to define ingress and egress data rate limits for each
queue on the Switch.
Table 18 Rate Limit Profile Setup
LABEL DESCRIPTION
Name Enter a descriptive name (up to 20 characters) for identification purposes.
Ingress Commit
Rate(Kbps)
Select the checkbox and enter the guaranteed bandwidth allowed in kilobits per second
(Kbps) for the incoming traffic flow through a port. Enter a number between 64 and
1000000. Alternatively, clear the checkbox to not use the rate limit.
Note: The sum of commit rate cannot be greater than or equal to the uplink bandwidth.
Ingress Peak
Rate(Kbps)
Select the checkbox and enter the maximum bandwidth allowed in kilobits per second
(Kbps) for the incoming traffic flow through a port when burst traffic occurs. The incoming
traffic over this peak rate will be discarded. Enter a number between 64 and 1000000.
Alternatively, clear the checkbox to not use the rate limit.
Note: The peak rate should be greater than the commit rate.
Egress Rate(Kbps) Select the checkbox and enter the maximum bandwidth allowed in kilobits per second
(Kbps) for the outgoing traffic flow through a port. Enter a number between 64 and
1000000. Alternatively, clear the checkbox to not use the rate limit.
Add Click Add to save the new rule to the switch. Then a summary table displays in the bottom
of the screen.
Cancel Click Cancel to reset the fields to your previous configuration.
Clear Click Clear to clear the fields to the factory defaults.
Name This field displays the descriptive name for the rate limit profile.
Ingress Commit This field displays the ingress committed rate limit for the port(s)
Ingress Peak This field displays the ingress peak rate limit for the port(s)
Egress This field displays the egress rate limit for the port(s).
Applied Ports This field displays the port number(s) to which this profile is applied.
You can apply a rate limit profile to a port in the Port Setup screen.
Delete Check the rule(s) that you want to remove in the Delete column and then click the
Delete button.
Cancel Click Cancel to clear the selected checkboxes in the Delete column.