Chapter 3 Hardware Overview
VES1724-56 User’s Guide
29
5 Connect the fiber optic cables to the transceiver.
Figure 8 Transceiver Installation Example
Figure 9 Connecting the Fiber Optic Cables
3.1.3.2 Transceiver Removal
Use the following steps to remove a mini-GBIC transceiver (SFP module).
1 Remove the fiber optic cables from the transceiver.
2 Open the transceiver’s latch (latch styles vary).
3 Pull the transceiver out of the slot.
Figure 10 Removing the Fiber Optic Cables
Figure 11 Opening the Transceiver’s Latch Example
Figure 12 Transceiver Removal Example
3.1.4 Management Port
The MGMT (management) port is used for local management. Connect directly to this port using an
Ethernet cable. You can configure the Switch via Telnet or the Web Configurator.
To Next Page
Loading...
