Chapter 8 Basic Setting
VES1724-56 User’s Guide
87
8.11 Hardware Alarm Profile
Click Basic Setting > Hardware Alarm Profile to display the screen as shown. Hardware alarm
profile defines CPU, packet buffer, memory utilization thresholds and CPU, DSP, ADT temperature
thresholds. The Switch sends a hardware alarm once it detects one usage over its pre-defined
threshold. Configure the thresholds and click Apply to save your changes or click Cancel to reload
the previous settings for this screen.
Figure 44 Hardware Alarm Profile Setup
8.12 CPE Port Status
Use this screen to view all DSL port status and details about the connected CPE devices.
Figure 45 CPE Port Status
The following table describes the labels in this screen.
Table 20 Basic Setting > CPE Port Status
LABEL DESCRIPTION
Port This is the number of a port.
Link State This field displays Showtime when the DSL connection is up. Otherwise, it displays Idle,
Handshake or Training during the DSL line establishment. If you perform a DELT test, this
field will display LD_Testing. The state changes to LD_Done after the DELT test is
completed.
Actual NDR
US/DS(Mbps)
This field displays the actual upstream/downstream net data rate in Mbps.
Model This field displays the model name of the CPE device connected to this port. NA displays if it
is not available.
To Next Page
Loading...
