Chapter 9 VDSL Setup
VES1724-56 User’s Guide
104
9.3 VDSL Template Setup
The Switch supports one line profile and one channel profile configured in a VDSL template. Use this
screen to add, modify or delete a VDSL template.
To configure or view VDSL templates, click VDSL Setup > VDSL Profile to display the screen as
shown next.
Note: You can configure up to 60 VDSL templates.
Figure 54 VDSL Template Setup
The following table describes the labels in this screen.
Table 33 VDSL Template Setup
LABEL DESCRIPTION
Name Enter a descriptive name to identify this template.
Line Profile Select a line profile for this VDSL template. You can configure line profiles by
clicking the LineProfile link in the right-top corner of the screen.
Channel Profile Select a channel profile for this VDSL template. You can configure channel
profiles by clicking the ChanProfile link in the right-top corner of the screen.
Inm Profile Select an INM profile for this VDSL template. You can configure channel profiles
by clicking the InmProfile link in the right-top corner of the screen.
Rate Adaption Ratio
Channel1 This field displays the transmission rate distribution ratio between upstream
and downstream traffic for channel 1 in this template.
Add Click Add to save the new VDSL template to the Switch. It then displays in the
summary table at the bottom of the screen.
Cancel Click Cancel to reset the fields to your previous configuration.
Clear Click Clear to clear the fields to the factory defaults.
Name This field displays the descriptive name for each configured VDSL template.
Line Profile This field displays the line profile name configured in each VDSL template.
Channel Profile This field displays the channel profile name configured in each VDSL template.
To Next Page
Loading...
