VES1724-56 User’s Guide 370
CHAPTER 44
CFM Action
This chapter explains the CFM (Connectivity Fault Management) Action screen. Refer to
Section 28.1 on page 274 to see more information.
44.1 CFM Action
Click Management and CFM Action in the navigation panel to open this screen. Use this screen to
manage any connectivity faults.
Figure 240 CFM Action
The following table describes the labels in this screen.
Table 177 CFM Action
LABEL DESCRIPTION
Continuity
Check
Select a level, type a VLAN ID and click Enable or Disable to start or disable
sending the connectivity check packets in this MD (Maintenance Domain).
Link Trace Select this to trace the nodes on this link.
Loop Back Select this to perform a loopback test on this link.
Level Select an MD level (0-7).
VID Type an MA VLAN ID (0-4096) under the MD level.
MEPID Type an MEP ID to specify which MEP port on the device initiates the action.
To Next Page
Loading...
